Configuration Guides

3CX

DIDWW SIP Trunks can be used with 3CX IP PBX for Outbound calls. The following guide will explain the steps necessary to configure the 3CX IP PBX.

Note

This guide has been created with 3CX Version 16.0.9.

Getting Started

Before you begin, you will need to create Outbound trunk on DIDWW User Panel.

Create an Outbound trunk.

Step 1. In the management console of 3CX go to your SIP Trunks. (Fig.1)

../../_images/sip_trunk.png

Fig. 1. “Main SIP Trunk” window.

Step 2. In the SIP Trunks section click on Import Provider (Fig.2)

../../_images/import_provider.png

Fig. 2. “Import Provider” window.

Step 3. Upload the file depending on the type of traffic (outbound) and enter your DID number as a Main Trunk No. (Fig.3)

Note

If the file opens as a New Tab with XML source code, use “Save As” on this new tab to save this file as XML.

../../_images/import_trunk_DID_number.png

Fig. 3. “Main Trunk No” window.

Step 4. Enter the authentication details of your DIDWW Outbound Trunk in the fields “Authentication ID” and “Authentication Password” (Fig.4).

../../_images/sip_outgoing_settings.png

Fig. 4. “Authentication ID and Authentication Password” section.

Step 5. Go to outbound rules section in the menu and click add. Enter the Rule name and apply the routing rules for outbound calls. In Route 1 select the Outbound routing SIP trunk of DIDWW (Fig.5).

../../_images/outbound_rule_set.png

Fig. 5. “Outbound Rules settings” window.

Note

Inbound call configuration guide for 3CX can be found here